Dalton Sprockets & Gears
Dalton Sprockets & Gears
| Dalton Sprockets For Use In OSD
Units Specialy ground sprockets are recommended for use with all Torque Limiters. Both faces of Dalton OSD sprockets are ground to approximately a 32 micro-inch finish. Uniform surfaces and parallel faces insure that Dalton OSD's will maintain proper torque release and re-engagement much longer than units without special sprockets. In addition, fibers last longer and OSD's require less maintenance. |
 |
| MINIMUM SIZE SPROCKETS TO FIT OSD UNIT | |||||||||
| OSD-131 | OSD-225 | OSD-256 | OSD-337 | OSD-362 | OSD-450 | OSD-493 | OSD-600 | OSD-750 | OSD-900 |
| 25A20G | 25A32G | 35A25G | 35A31G | 35A34G | 35A41G* | 41A35G* | 41A52G* | 40A52G* | 60A41G* |
| 35A14G | 35A22G | 41A20G | 41A25G | 41A26G | 41A32G | 40A35G* | 40A42G* | 50A42G* | 80A32G |
| 41A12G | 41A18G | 40A20G | 40A25G | 40A26G | 40A32G | 50A28G* | 50A34G | 60A35G* | 100A26G |
| 40A12G | 40A18G | 50A17G | 50A21G | 50A22G | 50A26G | 60A24G | 60A30G | 80A27G | 120A22G |
| 50A10G | 50A15G | 60A15G | 60A18G | 60A19G | 60A23G | 80A19G | 80A22G | 100A22G | 140A20G |
| 60A13G | 80A14G | 80A15G | 80A18G | 100A16G | 100A19G | 120A19G | 160A18G | ||
| 100A15G | 120A14G | 120A17G | 140A17G | ||||||
| 120A13G | 140A15G | 160A15G | |||||||
| 160A14G | |||||||||
Dalton Drive Tensioners & Idler Sprockets
|
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
